Home Contents Glossary Search Help

Full simulation
Previous Up

 

Have a go!

Here you have full control over all the HV bias and amplifier settings.

  • First, switch on the amplifier power,
  • Now switch on the HV Bias power,
  • Slowly ramp up the bias voltage to about 2500 - 3000V,
  • You should now have an input signal with a low noise level,
  • Use the scrollbar on the left to bring the source closer to the detector,
  • Use the other controls to observe their effect on the oscilloscope signal.
  • Use the Run/Stop button to freeze the display.
 

The University of Liverpool
1999, 2000 The University of Liverpool, Department of Physics

EPSRCProject funded by The Engineering and Physical Sciences Research Council

Materials Teaching Educational ResourcesWebsite developed and maintained by the MATTER Project